Precor EFX546 Manuel de service télécharger pdf (Page 8)

C546 Elliptical Fitness Crosstrainer

Page 8

Procedure 3.2 - Accessing the Diagnostic Program (version

The EFX diagnostic software cycles through the following tests:

• LED Diagnostics

• Power Bits

• Lift Calibration Number

• Heart Rate

• Keypad Test

Procedure

1. Plug the power cord into the wall outlet, then turn on the EFX with the circuit breaker.

2. Press keys RESET,5,1,7,6,5,7,6,1., sequentially.

3. Watch the upper display as the LED test progresses. The test will illuminate every LED on

the display. The test will illuminate the LED’s in a specific pattern. When you are familiar

with the pattern, it is easy to determine when a LED does not illuminate.

4. If you do not observe the LED illumination sequences described in Step 3...

THEN... OTHERWISE...

Replace the upper PCA as described The LED test passed successfully;

in Procedure 7.2 or 7.3. continue with the next step.

5. Power Bits will be displayed. Power bits indicates the amount of power being applied to the

eddy current magnets and will vary directly with the resistance. Press ENTER to continue.

6. With LIFT displayed in the right display window, watch the right display window (shown in

Diagram 3.1). Press the CROSSRAMP

▲ or CROSSRAMP ▼ keys one at a time. Verify that

the lift calibration number increments or decrements as each of the CROSSRAMP keys are

pressed.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 117 118

Pas de commentaire

Precor EFX546 Manuel de service Page 8