Precor EFX546 Manuel de service télécharger pdf (Page 68)

C546 Elliptical Fitness Crosstrainer

Page 68

6. Two cables are in the main frame tube. The lift motor cable and the interconnect cable(s).

Locate the interconnect cable connectors in the access hole and disconnect the

interconnect cables.

7. Tape the end of the replacement interconnect cable with the small (16 pin) connector to the

upper end of the old interconnect cable (display housing end).

8. Carefully pull the old interconnect cable out of the bottom access hole while feeding the new

interconnect cable into the unit. When the new cable is fully into the unit, remove the tape

and discard the old interconnect cable. Connect the two interconnect cables and push them

into the access hole.

9. Replace the display housing per Procedure 7.2, steps 14 to 18.

10. Remove the ground lead of the wrist strap from the EFX frame, then remove the wrist strap

from your arm.

11. Check the operation of the EFX as described in Section Four.

Replacing the Lower Interconnect Cable

12. Remove the rear cover. Remove the shield from the lower PCA. Disconnect the

interconnect cable from the lower PCA. (See Diagram 7.6)

13. Lay the EFX on it’s side. The upper and lower interconnect cables are connected in the

main frame tube. Locate the access hole in the main frame tube. (See Diagram 7.8).

14. Two cables are in the main frame tube. The lift motor cable and the interconnect cable(s).

Locate the interconnect cable connectors in the access hole and disconnect the

interconnect cables.

15. Connect the male connector of the replacement interconnect cable to the old interconnect

cable at the lower PCA end of the old interconnect cable.

16. Carefully pull the old interconnect cable out of the bottom access hole while feeding the new

interconnect cable into the unit. When the new cable is fully into the unit, remove the tape

and discard the old interconnect cable. Connect the two interconnect cables and push them

into the access hole.

17. Connect the new interconnect cable to the lower PCA.

18. Replace the shield on the lower PCA. Replace the rear cover.

19. Check the operation of the EFX as described in Section Four.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 117 118

Pas de commentaire

Precor EFX546 Manuel de service Page 68