Precor EFX546 Manuel de service télécharger pdf (Page 107)

C546 Elliptical Fitness Crosstrainerl

Page 107

Procedure 7.29 - Replacing a Power Entry Module

(version 2,3 units manufactured after 10-15-2000)

Procedure

Note: The power entry module on this EFX is a multifunction unit. It functions as a power entry

module, A.C. line fuse holder, on/off switch and A.C.ine filter.

1. Set the on/off switch in the off position. Remove the A.C. line cord from the A.C. outlet and

from the power entry module.

2. Remove the rear cover per Procedure 7.1.

Diagram 7.27 - Power Entry Module

3. Remove the blue wire from terminal D and the brown wire from terminal A of the power entry

module.

4. Remove the two screws that mount the power entry module to the rear cover support.

5. Open the fuse compartment and remove both fuses (See Procedure 7.30). Check both

fuses with an ohmmeter. They should read approximately 1Ω or less. Replace any fuse that

reads significantly high.

6. Install the tested fuses, from step 5, in the replacement power entry module.

Blue Wire

Brown Wire

Green Wire

Fuse

Access Door

On/Off

Switch

A.C. Input

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 117 118

Pas de commentaire

Precor EFX546 Manuel de service Page 107