Precor EFX546 Manuel de service télécharger pdf (Page 77)

C546 Elliptical Fitness Crosstrainerl

Page 77

9. Set the on/off switch in the “off” position. Do not exit the diagnostic program in the normal

manner. Exiting the diagnostic program will cause the lift to self center and invalidate the lift

calibration just performed.

10. On version 1, 2 units, raise the ramp assembly to a convenient height and slide the ramp

end cap into the ramp assembly. Hand tighten the four ramp end cap mounting screws and

then torque them to 100 in/lbs.

11. On version 3 units, raise the ramp assembly to a convenient height and slide the lift yoke

into the ramp assembly. Hand tighten the four lift yoke mounting screws and then torque

them to 240 in/lbs.

Diagram 7.12 - Ramp End Cap or Lift Yoke Mounting

12. Set the on/off switch in the “on” position. Thoroughly test all lift related functions per Section

Four.

13. Set the on/off switch in the “off” position, replace the front cover.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 117 118

Pas de commentaire

Precor EFX546 Manuel de service Page 77