Precor EFX546 Manuel de service télécharger pdf (Page 75)

C546 Elliptical Fitness Crosstrainerl

Page 75

Procedure 7.11 - Replacing the Lift Motor

Removing the Lift Motor

Note: This procedure references The version 1 & 2 units. The only difference in this procedure is

that on version 1, 2 units the lift motor mounts to the ramp via a ramp end cap. Version 3 units lift

motors mount to the ramp via a lift yoke. When replacing a lift motor on a version unit substitute

the word lift yoke for ramp end cap See Diagram 5.3.

1. Set the on/off switch in the “off” position. Remove the front cover as described in Procedure

7.1.

2. Remove the four screws that retain the ramp end cap or lift yoke to the ramp assembly.

Support the lift motor and ramp assembly as you separate the ramp end cap from the ramp

assembly. Lower the ramp assembly until it is resting on the frame. (See Diagram 7.10)

Diagram 7.10 - Lift Motor Mounting

Ramp End Cap

Ramp Assembly

Lift Motor

Drive Screw

Mounting

Screws

Leveller

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 117 118

Pas de commentaire

Precor EFX546 Manuel de service Page 75