Precor Electronic Console with the Pulse Feature 903 Manuel d'utilisateur télécharger pdf (Page 12)

page 12

Installing the Mounting Pads

Two adhesive-backed foam pads (one thick and one thin pad)

accompany your electronics option package. The thick pad is

used as a spacer and you place the reed switch on it. The thin

pad is positioned onto the flywheel and becomes the base for

the magnet.

CAUTION: Both pads require a 24-hour period to bond

properly to the equipment. Do not operate the treadmill

during this time.

Diagram 9

Place mounting

pad here

To install the mounting pads to the flywheel and side rail on your

903 or 904 treadmill, take the following steps:

1. Locate the area on the side rail between the right roller

guard and the deck of the treadmill. See Diagram 9.

Note: Right and left are determined by standing behind the

rear roller and facing the handrail(s).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Pas de commentaire

Precor Electronic Console with the Pulse Feature 903 Manuel d'utilisateur Page 12