C954, C956 Treadmill
Page 17
6. Version 3 units only If the drive belt tension is less than 70 or greater than 90 inch/pounds,
slightly loosen the four drive motor mounting bolts. The drive motor mounts on slotted holes
allowing the drive motor to be move forward or rearward. Move the drive motor forward or
rearwards, as required, until the belt gauge reads approximately 80 inch/pounds and tighten
the four drive motor mounting bolts. See Diagram 4.4. Momentarily remove the drive belt
tension gauge from the drive belt. Replace the drive belt tension gauge on the drive belt and
re-adjust the drive belt tension, if necessary. Torque the four drive motor mounting bolts to
180 inch pounds.
Diagram 4.3 - Drive Belt Adjustment Bolt (version 1 & 2 units)
Diagram 4.4 - Drive Belt Adjustment (version 3 units)
7. Re-install the hood.
8. Plug the line cord into the wall outlet and set the treadmill circuit breaker in the “on” position.
9. Check treadmill operation per Section 3.
Drive
Motor
Drive Belt
Adj. Bolt
Drive Motor
Mounting Bolt
Commentaires sur ces manuels